Shandong Xinkaite Bearing Co.,Ltd.
Unified Social Credit Code: 9137 1525MA3C 5428XP
Production Department
Address: Xu Village Industrial Garden, Gan Town, Guan County, Shandong
Tel: +86 635 5638235
Fax: +86 635 5638808
Mobile: +86 15563545668
Service Hotline: 4000 305204 Sales Department
Address: 314 Puli Mansion, Beixiaoxinzhuang West Street, Jinan City, Shandong
Tel: +86 15688862750
Fax: +86 531 87901699
WhatsApp: +86 15688862750
Skype: live:XinKaite
Email: xkte@xinkaite.com
What are the ways to deal with the heat problem of Conveyor idler roller
Clicks:3703 Date:12-27
Under normal circumstances, the Conveyor idler roller temperature should be about 30 degrees Celsius, the highest temperature does not exceed 70 degrees Celsius, otherwise, because the bearing temperature is too high due to deformation, severe cases will cause direct damage to the jaw crusher, what is more, directly lead to blasting machine. Therefore, time to alert the jaw crusher bearing temperature, especially in the summer comes, more urgent.
1. The wear of bearing or the damage of the cage. Two, the tight setting of the bushing in the axial movement. Three. Too much oil or oil is injected into the bearing. Four. The weight block of the flench wheel of the crusher is running and the frame is beating. Five, the oil hole is blocked and the oil is not added. Six, non bearing heating, but moving jaw seal sleeve and end cover friction heat or rack bearing seat double cover and the spindle rolling together, conflict fever.
1. keep the smooth clean of the bearing
The Conveyor idler roller leading clean bearing appearance should check before, then carefully check the bearing oil seal and its surrounding parts, if have shown adverse symptoms, must be replaced, bad oil seals will cause damage to bearing cloud and the formation of normal equipment downtime.
2. pay attention to the overlay of the bearing
Dont expose Conveyor idler roller to contaminant or wet air when looking at the bearing. If the operation is discontinued, the oil paper and plastic film or similar data shall be used to cover the machine. If it is possible to clean the unconcealment bearings without dismantled, it should be cleaned with oil brushes coated with brushes, then dried with a piece of uncoated cloth or dried with compressed air.
